|Place of Origin:||China|
|Minimum Order Quantity:||1 Unit|
|Mode Of Quality:||M2﹤1.2||Beam Diameter:||1.8±0.2mm|
|Beam Divergence Angle:||7.5±0.5m Full Angle||Working Frequency &duty Cycle:||0～25KHZ，0～100%DC|
|Max Heat Load:||﹤575w|
Sealed CO2 Laser Tube 9.3um wavelength for marking on PE , drinking Bottle Model D30I Long product Lifetime good price
Our laser machines offer extensive possibilities when it comes to the laser cutting and engraving of various materials, ranging from plexiglass to MDF, and from metal to glass.
Do you utilise a specific type of material and you want to know whether or not it can also be processed by our laser machines? If so, please send us a sample of the material and we will gladly test its processability for you, free of charge. If necessary, we can adjust the settings of our laser machines so that you too can work with them.
9.3um Wavelength laser tube is perfect laser source for maring on PE, some medical device companies also need it to use in dentistry .
Model D30 Laser Specification and working condition
|Continuous rated output Power||30w|
|Power stability rate||±5%|
|Mode of quality||M2﹤1.2|
|Beam divergence angle||7.5±0.5m full angle|
|Degree of polarization||Linear polarization(﹥100:1)parallel to width direction|
|Working frequency &duty cycle||0～25KHZ,0～100%DC|
|Dimension L x W x H||
|Input voltage||48VDC±2% range,Average current max 12A,required power supply could bear peak current 18A no less than 1mS.|
|Max Heat Load||﹤575w|
|Maximum hull temperature||﹤60℃(140℉)|
|Working environment temperature||5℃～40℃(41℉～104℉)|
1. Laser power is tested according to the temperature of laser which is 25℃,everytime the laser temperature rises 1℃,the output power will reduce 1%.
2. Definition of stabilization: ±(Pmax－Pmin)/(2Pmax)
3. Testing condition of stabilization: Warming up about 10mins,controlling duty cycle constantly,under the normal operating environment.
D30 Signal Interface Description and Connector Pinout
|PIN NO||SIGNAL DESCRIPTION|
( PWM+ orange white)
TTL logic input ；1=RF ON,0=RF OFF；1KΩ impedance;
This input turns on the laser. See Pin7,Control Enable
|2(+15V orange)||+15VDC±0.5VDC,Max output for customer using is 0.25A|
(Laser green white)
Laser status output
TTL logic output,1=LASER OK,0=LASER Fault;
When fault is not detected ,output valid.
Temperature status output
TTL logical output,1=normal temperature,0= Ultra high temperature;
When the case temperature is below 60℃, the output is valid
(Volt blue white )
Power and voltage status output
TTL logical output;1=normal voltage;
0= abnormal voltage
|6(GND Green)||For internal use. must ground connected|
(Enable brown white)
TTL Logical input；1= Laser control enable,0=Laser controlled shutdown
This input must be valid before RF is enabled to turn on the laser.
1.The connector uses the RJ-45 type.
2.The color noted on pin can correspond to color of the cable color our company sent together with the product.
Contact Person: amy