|Place of Origin:||Beijing, China|
|Minimum Order Quantity:||1 Unit|
|Packaging Details:||118*39*36cm Carton Package|
|Payment Terms:||L/C, T/T, D/A, Western Union|
|Supply Ability:||500 units/month|
|Average Power Range:||10-150W||Wavelength:||10.6um|
|Pulse Energy Range:||5-300 Mj||Beam Quality:||M²＜1.5|
|Pulse Frequency:||0-100 Khz||Duty Cycle Adjustable Range:||＜0-60%|
Long lifetime 150W RFCO2 Sealed metal laser tube Gas refilled High beam quality
The company has strong technical research and development capabilities and a high-quality, experienced technical research and development team.
The domestic advanced and highly automated production line, all internal components are assembled under the Class 10,000 Dust-free room.
Military-grade standard electronic components, mechanical workpiece tolerances accurate to 1-5us.
The internal lens purchases imported products to ensure their life and spot pattern, and the special mixture ratio increases the life and power of the laser.
M150 Laser specifications and using conditions
|Average power range||10-150w|
|Pulse energy range||5-300mj|
|Pulse rise and fall time||<90us|
|Stability of beam pointing||<200 urad|
|Divergence||<11.0mrad Full angle|
|Duty cycle range||0-60%|
|DC input Voltage||48V±1%|
|DC inout Current||50A,peak value:100A|
|Cooling way||water cooling|
|Environment temperature||5℃ to 40℃|
|Relative humidity||<95% non-condensing|
M150 Pin description(water cooled)
|DB25 connector||Wring instruction||Signal description|
Modulated input signal
|This terminal requires input differential signal to control the output laser,when the signal is effective (high level)there is laser output; when the signal is invalid (zero level), there is no laser output. The pulse width of the signal should between 10 and 998 ms,duty cycle less than 60% and the pulse frequency 0-100khz.|
Short circuit between pin3 and pin16
|RF amplifier enable,digital signal low efficiency, input low level allows the RF amplifier to work.|
1. 48V 50A power supply,need to GND
2. Note the dust protection of the laser output window. Prevent the lens from burning due to dust particles. Especially the way laser output window faces up.
3. Be careful to prevent backward reflection,any backward reflection can cause laser damage.
We suggest the front and rear end of the laser should not be completely fixed at the same time,avoid the deformation of the cavity due to the stress caused by the thermal expansion of the material.
4. The laser is water cooled, water cooler machine must be opened before the start of the laser.
If there are any problems during the usage of the laser, please contact us for your timely solution.Thank you.
Contact us immediately if you have any requirments,thank you very much.
Contact Person: tracy