|Place of Origin:||CHINA|
|Certification:||CE, ISO 9001|
|Minimum Order Quantity:||1 Unit|
|Delivery Time:||5 work days|
|Payment Terms:||T/T, L/C, L/C|
|Supply Ability:||100 unit|
|Beam Diameter:||1.8±0.2mm||Beam Divergence Angle:||7.5±0.5m Full Angle|
|Working Frequency &duty Cycle:||0～25KHZ，0～100%DC|
Metal RF CO2 Laser tube D30 especially for medical laser devices Fractional / Surgical Laser Devices
Beijing Davi Laser Technology Co., Ltd. is a professional manufacturer of metal Rf CO2 laser tubes, Laser tube D30 has been sold in market for more than 5 years . The high quality standard , stable performance has made D30 been well accepted by clients from domestic and overseas . DAVI Laser has been devoted to improvement of product technology and maintenance service , by now, DAVI laser is the main supplier to many laser medical device manufactures and established good reputation .
The new Version D30 is more quite , compact and portable, easy to operation , accept your machine's variable treatment patterns , as well as no regular maintenance Needed and 24 months long warrantee period .
Model D30 Laser Specification and working condition
|Continuous rated output Power||30w|
|Power stability rate||±5%|
|Mode of quality||M2﹤1.2|
|Beam divergence angle||7.5±0.5m full angle|
|Degree of polarization||Linear polarization(﹥100:1)parallel to width direction|
|Working frequency &duty cycle||0～25KHZ,0～100%DC|
|Dimension L x W x H||
|Input voltage||48VDC±2% range,Average current max 12A,required power supply could bear peak current 18A no less than 1mS.|
|Max Heat Load||﹤575w|
|Maximum hull temperature||﹤60℃(140℉)|
|Working environment temperature||5℃～40℃(41℉～104℉)|
1.Laser power is tested according to the temperature of laser which is 25℃,everytime the laser temperature rises 1℃,the output power will reduce 1%.
2.Definition of stabilization: ±(Pmax－Pmin)/(2Pmax)
3.Testing condition of stabilization: Warming up about 10mins,controlling duty cycle constantly,under the normal operating environment.
D30 Signal Interface Description and Connector Pinout
|PIN NO||SIGNAL DESCRIPTION|
( PWM+ orange white)
TTL logic input ；1=RF ON,0=RF OFF；1KΩ impedance;
This input turns on the laser. See Pin7,Control Enable
|2(+15V orange)||+15VDC±0.5VDC,Max output for customer using is 0.25A|
(Laser green white)
Laser status output
TTL logic output,1=LASER OK,0=LASER Fault;
When fault is not detected ,output valid.
Temperature status output
TTL logical output,1=normal temperature,0= Ultra high temperature;
When the case temperature is below 60℃, the output is valid
(Volt blue white )
Power and voltage status output
TTL logical output;1=normal voltage;
0= abnormal voltage
|6(GND Green)||For internal use. must ground connected|
(Enable brown white)
TTL Logical input；1= Laser control enable,0=Laser controlled shutdown
This input must be valid before RF is enabled to turn on the laser.
1.The connector uses the RJ-45 type.
2.The color noted on pin can correspond to color of the cable color our company sent together with the product.
A corner of DAVI Laser company factory
Contact Person: tracy