|Place of Origin:||China-Beijing|
|Minimum Order Quantity:||1 unit|
|Packaging Details:||61*29*25CM (LxWxH) Carton|
|Delivery Time:||Delivery in 5days after got payment|
|Payment Terms:||D/P, Western Union, L/C, T/T|
|Supply Ability:||500units/per month|
|Polarization:||>100 To 1 Fixed Linear||Wavelength:||10.6um|
|Beam Divergence:||7.5±0.5 Mrad||Rated Power:||≥30W|
30W Laser Tube RF metal Co2 source made in China manufacturer medical lasers
Glass marking applications were once thought of as outside the domain of CO2 lasers since glass readily absorbs the laser radiation, causing fractures to relieve thermal stress. DAVI pioneered glass marking with CO2 lasers, which now replaces sandblasting as the preferred method due to the accuracy of the marking and the lower costs of downtime associated with set up and change-over. The most common lasers power used is 25W – 30W to reduce fracturing to acceptable levels.
Applications testing services are provided at no cost to qualified users, and there is no purchase obligation. We are confident that users will realize the benefits of our high performance CO2 lasers, and will see the advantage and value when integrating DAVI lasers in their processing systems.
D30 Specifications and using condition
|Beam Divergence||7.5±0.5 mrad|
|Polarization||>100 to 1 fixed linear|
|Modulation||TTL up to 25kHz|
|Input voltage||48VDC <±2% regulation <1%P-P Noise/Ripple|
|Input DC current||≤12A|
|Ambient Air Temperature||5℃ to 40℃|
Those characteristics are guaranteed ;all other stated characteristics are typical.
Specifications are subject to change without notice.
D30 Signal Interface and Pin Description
|PIN NO||SIGNAL DESCRIPTION|
|1(PWM Orange and white)||
TTL logic input
1=RF ON,0=RF OFF；1KΩ impedance.
This input turns on the laser.(See also Pin 7,Control Enable, below)
|2(+15V Orange)||+15 VDC±0.5VDC,0.25 A Max output for customer use|
|3(Laser Green and white)||
TTL logic output,1=LASER OK,0=LASER Fault;
Output is asserted when no faults(SWR, Temp or Volt.)are detected
TTL logical output,1=Temp ok,0=Temp fault;
Output is asserted when temperature is below 60℃
|5(Volt Blue and white)||
Power and voltage OK
TTL logical output;1= voltage ok,0=voltage fault;
Output is asserted when DC supply voltage is below max. value
|6(GND Green)||For internal use. must be grounded|
|7(Enable Brown and white)||
TTL Logical input；1= Laser control enable,0= Laser controlled disabled
This input must be asserted before RF enable can be used to turn on the laser.
1) The connector uses the RJ-45 type
2) These specifications are subject to change
Contact me anytime if you need this laser.
Thanks and regards
Contact Person: sarah