|Place of Origin:||Beijing, China|
|Minimum Order Quantity:||1 Unit|
|Packaging Details:||118*39*36cm (LxWxH) Carton Package|
|Payment Terms:||D/P, Western Union, L/C, T/T|
|Supply Ability:||500units/per month|
|Input Current:||50A||Humidity:||95% Non-condesing|
|Cooling Water Folw Rate:||5.7L/min||Duty Cycle:||0-60%|
Sealed ceramic core metal case aluminum 100w CO2 Laser Tube for 3D cutting
Introduction of lasers:
Light, when used as a manufacturing tool, is fascinating and compelling; it offers virtually infinite potential in material processing applications, which are as broad as the technologies enabled by them.
Our industrial lasers and laser systems cover a broad spectrum of technologies, wavelengths, and output power. Whatever the size and scale of your materials processing task.
M100 Laser specifications and using conditions
|Average power range||10-100w|
|Pulse energy range||5-200mj|
|Pulse rise and fall time||<90us|
|Stability of beam pointing||<200 urad|
|Divergence||<11.0mrad Full angle|
|Duty cycle range||0-60%|
|DC input Voltage||48V±1%|
|DC inout Current||50A,peak value:100A|
|Cooling way||water cooling|
|Environment temperature||5℃ to 40℃|
|Relative humidity||<95% non-condensing|
M100 Pin description(water cooled)
|DB25 connector||Wring instruction||Signal description|
Modulated input signal
|This terminal requires input differential signal to control the output laser,when the signal is effective (high level)there is laser output; when the signal is invalid (zero level), there is no laser output. The pulse width of the signal should between 10 and 998 ms,duty cycle less than 60% and the pulse frequency 0-100khz.|
Short circuit between pin3 and pin16
|RF amplifier enable,digital signal low efficiency, input low level allows the RF amplifier to work.|
1. 48V 50A power supply,need to GND
2. Note the dust protection of the laser output window. Prevent the lens from burning due to dust particles. Especially the way laser output window faces up.
3. Be careful to prevent backward reflection,any backward reflection can cause laser damage.
We suggest the front and rear end of the laser should not be completely fixed at the same time,avoid the deformation of the cavity due to the stress caused by the thermal expansion of the material.
4. The laser is water cooled, water cooler machine must be opened before the start of the laser.
If there are any problems during the usage of the laser, please contact us for your timely solution.Thank you.
Contact Person: ella