|Place of Origin:||China-Beijing|
|Minimum Order Quantity:||1 unit|
|Packaging Details:||762*145*164mm wooden package|
|Delivery Time:||500units/per month|
|Payment Terms:||L/C, T/T, D/A, Western Union|
|Power Stability Rate:||<±10%||Wavelength:||10.6um|
|Max Heat Load:||2400w||Mode Of Quality:||<1.5|
|Beam Divergence Angle:||<9 Mrad||Cooling Water Temperature Range:||10-35 Degree|
rf co2 laser tube,
sealed co2 laser tube
Used on medical machine this is Water Cooled Co2 laser source which made in China
Something about lasers and company:
We work alongside them using our in-depth knowledge and providing them with cutting-edge solutions – often customised – which are always able to ensure excellent performance in terms of costs, operating efficiency and quality of the end product.
DAVI Laser products are the result of the commitment of our R&D department. Behind the most advanced technologies are the men who were able to imagine them, design them and create them technically. Our new laser systems are the result of team work that shares skills, capabilities and talent.
M150 Laser specifications and using conditions
|Average power range||10-150w|
|Pulse energy range||5-200mj|
|Pulse rise and fall time||<90us|
|Stability of beam pointing||<200 urad|
|Divergence||<11.0mrad Full angle|
|Duty cycle range||0-60%|
|DC input Voltage||48V±1%|
|DC inout Current||50A,peak value:100A|
|Cooling way||water cooling|
|Environment temperature||5℃ to 40℃|
|Relative humidity||<95% non-condensing|
M150 Pin description(water cooled)
|DB25 connector||Wring instruction||Signal description|
Modulated input signal
|This terminal requires input differential signal to control the output laser,when the signal is effective (high level)there is laser output; when the signal is invalid (zero level), there is no laser output. The pulse width of the signal should between 10 and 998 ms,duty cycle less than 60% and the pulse frequency 0-100khz.|
Short circuit between pin3 and pin16
|RF amplifier enable,digital signal low efficiency, input low level allows the RF amplifier to work.|
1)48V 50A power supply,need to GND
2) Note the dust protection of the laser output window. Prevent the lens from burning due to dust particles. Especially the way laser output window faces up.
3) Be careful to prevent backward reflection,any backward reflection can cause laser damage.
We suggest the front and rear end of the laser should not be completely fixed at the same time,avoid the deformation of the cavity due to the stress caused by the thermal expansion of the material.
4) The laser is water cooled, water cooler machine must be opened before the start of the laser.
If there are any problems during the usage of the laser, please contact us for your timely solution.Thank you.
Contact Person: Tracy Xu