|Place of Origin:||China|
|Minimum Order Quantity:||1 Unit|
|Power Stability Rate:||±5%||Working Frequency &duty Cycle:||0～25KHZ，0～100%DC|
|Dimension L X W X H:||357×92.5×142mm||Working Environment Temperature:||5℃～40℃(41℉～104℉)|
Davi Metal RF co2 laser tube D30 Provide perfect Laser Source for Laser Engraving Machine Laser Marking Machine
CO2 lasers have a wavelength that is 10 times longer than a YAG,YVO4 or Fibre laser.
This is the longest wavelength among widely used industrial lasers. CO2 lasers, as the name implies generates the laser medium through stimulation of CO2 gas
Co2 Laser Marking machines provides solution for laser marking nonmetal materials, such as Crafts, Furniture, Glasses, Woods, PVC, Lightings, Advertising and decorating, paper, etc. . RF co2 laser tube D30 as the main component of the laser machine, it provides 10.6μm laser source . The laser tube is extremely compact, modular easy for assembly and operation .
Davi D30 has been sold in the market since 2014, for its realiable quality , long lifetime and competitive price , it has been good accepted by more and more clients . In 2017 , the sales quantity reaches over 5000 units per year .
Model D30 Laser Specification and working condition
|Continuous rated output Power||30w|
|Power stability rate||±5%|
|Mode of quality||M2﹤1.2|
|Beam divergence angle||7.5±0.5m full angle|
|Degree of polarization||Linear polarization(﹥100:1)parallel to width direction|
|Working frequency &duty cycle||0～25KHZ,0～100%DC|
|Dimension L x W x H||
|Input voltage||48VDC±2% range,Average current max 12A,required power supply could bear peak current 18A no less than 1mS.|
|Max Heat Load||﹤575w|
|Maximum hull temperature||﹤60℃(140℉)|
|Working environment temperature||5℃～40℃(41℉～104℉)|
1.Laser power is tested according to the temperature of laser which is 25℃,everytime the laser temperature rises 1℃,the output power will reduce 1%.
2.Definition of stabilization: ±(Pmax－Pmin)/(2Pmax)
3.Testing condition of stabilization: Warming up about 10mins,controlling duty cycle constantly,under the normal operating environment.
D30 Signal Interface Description and Connector Pinout
|PIN NO||SIGNAL DESCRIPTION|
( PWM+ orange white)
TTL logic input ；1=RF ON,0=RF OFF；1KΩ impedance;
This input turns on the laser. See Pin7,Control Enable
|2(+15V orange)||+15VDC±0.5VDC,Max output for customer using is 0.25A|
(Laser green white)
Laser status output
TTL logic output,1=LASER OK,0=LASER Fault;
When fault is not detected ,output valid.
Temperature status output
TTL logical output,1=normal temperature,0= Ultra high temperature;
When the case temperature is below 60℃, the output is valid
(Volt blue white )
Power and voltage status output
TTL logical output;1=normal voltage;
0= abnormal voltage
|6(GND Green)||For internal use. must ground connected|
(Enable brown white)
TTL Logical input；1= Laser control enable,0=Laser controlled shutdown
This input must be valid before RF is enabled to turn on the laser.
1.The connector uses the RJ-45 type.
2.The color noted on pin can correspond to color of the cable color our company sent together with the product.
Contact Person: tracy