|Place of Origin:||Beijing, China|
|Minimum Order Quantity:||1 Unit|
|Payment Terms:||D/P, L/C, T/T, Western Union, MoneyGram|
|Supply Ability:||1000 units per month|
|Material:||Metal Sealed,ceramic Core||Cooling:||Air Cooled|
|Wavelength:||9.3μm||Model Of Quality:||M2﹤1.2|
Ceramic laser tube D30i stable machine perfect working in laser systems
Chinese Independent research and development factory
DAVI Lasers is a reliable company for expert advice and good service in the field of co2 laser beam source. Superior beam quality,favourable price, long product lifetime ,efficient technical support are the main strengths of our products and service.
Continuous investments in research and innovation are the fundamental drivers of our growth, allowing us to develop new technologies and perfect those currently existing for laser Marking machines. We serve our customers and industrial partners with our heads, but also and above all with our hearts.
For effortless lasering of wood, acrylics, steel and paper!
Our laser machines are suitable for the engraving and cutting of many types of materials, ranging from metal to plastics, and from leather to glass.
D30 specification and working condition
|Continuous rated output Power||30w|
|Power stability rate||±5%|
|Mode of quality||M2﹤1.2|
|Beam divergence angle||7.5±0.5m full angle|
|Degree of polarization||Linear polarization(﹥100:1)parallel to width direction|
|Working frequency &duty cycle||0～25KHZ,0～100%DC|
|Dimension L x W x H||
|Input voltage||48VDC±2% range,Average current max 12A,required power supply could bear peak current 18A no less than 1mS.|
|Max Heat Load||﹤575w|
|Maximum hull temperature||﹤60℃(140℉)|
|Working environment temperature||5℃～40℃(41℉～104℉)|
1. Laser power is tested according to the temperature of laser which is 25℃,everytime the laser temperature rises 1℃,the output power will reduce 1%.
D30 Signal Interface Description and Connector Pinout
|PIN NO||SIGNAL DESCRIPTION|
( PWM+ orange white)
TTL logic input ；1=RF ON,0=RF OFF；1KΩ impedance;
This input turns on the laser. See Pin7,Control Enable
|2(+15V orange)||+15VDC±0.5VDC,Max output for customer using is 0.25A|
(Laser green white)
Laser status output
TTL logic output,1=LASER OK,0=LASER Fault;
When fault is not detected ,output valid.
In case of temperature failure, the case temperature is below 60℃.
Temperature status output
TTL logical output,1=normal temperature,0= Ultra high temperature;
When the case temperature is below 60℃, the output is valid
(Volt blue white )
Power and voltage status output
TTL logical output;1=normal voltage;
0= abnormal voltage
|6(GND Green)||For internal use. must ground connected|
(Enable brown white)
TTL Logical input；1= Laser control enable,0=Laser controlled shutdown
This input must be valid before RF is enabled to turn on the laser.
1. The connector uses the RJ-45 type.
2. The color noted on pin can correspond to color of the cable color our company sent together with the product.
Contact Person: ella